PRODUCT DESCRIPTION
Loctite ECCOBOND UF-3513HF provides the following product characteristics:
Technology Epoxy
Appearance Silver
Product Benefits ● Electrically conductive
● One component
● Low viscosity
● No bleed
● Good dispense behavior
● Fast cure at high temperatures
● Long shelf life at room temperature
● High bond strength
● Heat resistant after cure
Operating Temperature 150oC
Cure Heat cure
Filler Type Silver
Application Assembly
Loctite eccobond-3513 adhesive is designed for use in automated
assembly and in-line curing operations.
TYPICAL PROPERTIES OF UNCURED MATERIAL
Viscosity, 10 rpm @ 25°C, mPa????s (cP) 40,000
Density , g/cm3 3
Pot life @ 18 to 25 °C, weeks >2
Shelf Life @ -40 to -18°C (from date of manufacture),
months
6
Flash Point - See MSDS
TYPICAL CURING PERFORMANCE
Cure Schedule
Convection Oven:
1hour @ 100°C
45minutes @ 120°C
20minutes @ 150°C
Hot Plate:
60seconds maximum @ 180 to 190°C
Properties of the cured material will depend upon the cure schedule
used. Low temperature cure will reduce electrical conductivity.
The above cure profile is a guideline recommendation. Cure conditions
(time and temperature) may vary based on customers' experience and
their application requirements, as well as customer curing equipment,
oven loading and actual oven temperatures.
TYPICAL PROPERTIES OF CURED MATERIAL
Electrical Properties:
Volume Resistivity, ohms-cm:
Cure @ 180oC 2×10-4
Cure @ 100oC 1×10-3
TYPICAL PERFORMANCE OF CURED MATERIAL
Miscellaneous:
Tensile Lap Shear Strength N/mm2 12
(psi) (1,740)
GENERAL INFORMATION
For safe handling information on this product, consult the
Material Safety Data Sheet, (MSDS).
DIRECTIONS FOR USE
1. Complete cleaning of the substrates should be performed
to remove contamination such as oxide layers, dust,
moisture, salt and oils which can cause poor adhesion or
corrosion in a bonded part.
2. Frozen storage of uncured material is recommended to
maintain viscosity and may be helpful in retarding settling
of the silver filler.
3. Packages removed from storage must be allowed to
return to ambient temperature before use. This normally
takes 2hours for a 310cc cartridges.
4. ICP-3513 is applied by dispense.
Not for product specifications
The technical data contained herein are intended as reference
only. Please contact your local quality department for
assistance and recommendations on specifications for this
product.
Storage
Store product in the unopened container in a dry loca